TSL2569T【PDF 9/37 页】IC LIGHT TO DGTL CONV 6-TMB

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录58

5页 6页 7页 8页 [9页]10页 11页 12页 13页

TSL2568, TSL2569

LIGHT-TO-DIGITAL CONVERTER

TAOS091D DECEMBER 2008

The LUMENOLOGY r Company

www.taosinc.com

PRINCIPLES OF OPERATION

Analog-to-Digital Converter

The TSL256x contains two integrating analog-to-digital converters (ADC) that integrate the currents from the

channel 0 and channel 1 photodiodes. Integration of both channels occurs simultaneously, and upon completion

of the conversion cycle the conversion result is transferred to the channel 0 and channel 1 data registers,

respectively. The transfers are double buffered to ensure that invalid data is not read during the transfer. After

the transfer, the device automatically begins the next integration cycle.

Digital Interface

Interface and control of the TSL256x is accomplished through a two-wire serial interface to a set of registers

that provide access to device control functions and output data. The serial interface is compatible with System

Management Bus (SMBus) versions 1.1 and 2.0, and I

C bus Fast-Mode. The TSL256x offers three slave

addresses that are selectable via an external pin (ADDR SEL). The slave address options are shown in Table 1.

Table 1. Slave Address Selection

ADDR SEL TERMINAL LEVEL

SLAVE ADDRESS

SMB ALERT ADDRESS

GND

0101001

0001100

Float

0111001

0001100

VDD

1001001

0001100

NOTE: The Slave and SMB Alert Addresses are 7 bits. Please note the SMBus and I

C protocols on pages 9 through 12. A read/write bit should

be appended to the slave address by the master device to properly communicate with the TSL256X device.

SMBus and I

C Protocols

Each Send and Write protocol is, essentially, a series of bytes. A byte sent to the TSL256x with the most

significant bit (MSB) equal to 1 will be interpreted as a COMMAND byte. The lower four bits of the COMMAND

byte form the register select address (see Table 2), which is used to select the destination for the subsequent

byte(s) received. The TSL256x responds to any Receive Byte requests with the contents of the register

specified by the stored register select address.

The TSL256X implements the following protocols of the SMB 2.0 specification:

D Send Byte Protocol

D Receive Byte Protocol

D Write Byte Protocol

D Write Word Protocol

D Read Word Protocol

D Block Write Protocol

D Block Read Protocol

The TSL256X implements the following protocols of the Philips Semiconductor I

C specification:

D I

C Write Protocol

D I

C Read (Combined Format) Protocol

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式